Soft and hard layer horizontal cutting device is used for cutting the large size panel from the production line into finished product,Usually the panel from production line is 1200*2400mm,and after this equipment then one-time to be cutting into 1200*600mm finished product.This equipment has high efficient,simple construction and easy operation.
Soft and hard layer horizontal straddle cutting device firstly transfer the panel into cutting assembly,then the tip cylinder block lift to ward off the panel,make the panel vertical orientation;Side cylinder block stretch out to push the panel to fixed side baffles and clamp,make the panel horizontal orientation’Four power head fall down at the same time,compress roller compress panel,power head drive the disk saw to cut the panel from the origin point,after cutting,power head lift to original position and wait for next work cycle.

1）A set of transmission roller,length is about 7 meters;

2）Power cutting head 4 pcs；

3）Cutting assembly 1 set

4）driving motor power is equipped with each saw 3kw(recommend power is 1.5kw),rotate speed is 2800r/min;

5) Horizontal cutting speed is not lower than 20m/min,after horizontal cutting  panel’s size is 1200*600mm

6) Each power head has a shield and a suction inlet with diameter 140mm.

7) Adopt Siemens PLC automatic control,cooperate with overall production line;Electric components and main production line are consistent.
8) Cutting precision:
Allowed Length Tolerance： ±2mm
Allowed Width Tolerance： ±1mm
Allowed Diagonal Tolerance： ±3mm